What is the problem?
Printer stopped after printing approximately 15 minutes
What did you already try to solve it?
Nothing
Logs (octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support!)
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible)
Ultimaker 2
Latest OctoPi (NOT rc)
Raspberry Pi 3B+
octoprint.log (66.5 KB)
Serial.log too big so I paste the last lines here:
2020-02-05 08:57:05,202 - Send: N40562 G1 X155.05 Y44.27 E496.7540792
2020-02-05 08:57:05,216 - Recv: ok
2020-02-05 08:57:05,222 - Send: N40563 G1 X154.925 Y44.937 E496.7598394
2020-02-05 08:57:05,233 - Recv: ok
2020-02-05 08:57:05,238 - Send: N40564 G1 X154.767 Y45.58 E496.76545101
2020-02-05 08:57:05,249 - Recv: Error:Line Number is not Last Line Number+1, Last Line: 61486
2020-02-05 08:57:05,252 - Recv: Resend: 61487
2020-02-05 08:57:05,253 - Printer requested line 61487 but no sufficient history is available, can't resend
2020-02-05 08:57:05,259 - Changing monitoring state from "Printing" to "Error: Printer requested line 61487 but no sufficient history is available, can't resend"
2020-02-05 08:57:05,274 - Send: M112
2020-02-05 08:57:05,292 - Send: N40565 M11235
2020-02-05 08:57:05,298 - Send: N40566 M104 T0 S032
2020-02-05 08:57:05,303 - Send: N40567 M140 S0101
2020-02-05 08:57:05,347 - Changing monitoring state from "Error: Printer requested line 61487 but no sufficient history is available, can't resend" to "Offline (Error: Printer requested line 61487 but no sufficient history is available, can't resend)"
2020-02-05 08:57:05,367 - Connection closed, closing down monitor
2020-02-05 08:57:05,867 - Closing down send loop