No update at all the way

Get Help
1

What is the problem?

No update, after all the guides in here i could not update, it is not on python 2.0, not on overheat, good power supply

What did you already try to solve it?

every guide i could find on git hub, even sudo apt-get update && upgrade

Have you tried running in safe mode?

YES

Did running in safe mode solve the problem?

nein

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20220520234635.zip (41.6 KB)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

browser.user_agent : Mozilla/5.0 (Windows NT 10.0; Win64; x64) AppleWebKit/537.36 (KHTML, like Gecko) Chrome/99.0.4844.84 Safari/537.36 OPR/85.0.4341.79
connectivity.connection_check : 1.1.1.1:53
connectivity.connection_ok : true
connectivity.enabled : true
connectivity.online : true
connectivity.resolution_check : octoprint.org
connectivity.resolution_ok : true
env.hardware.cores : 4
env.hardware.freq : 1200
env.hardware.ram : 918188032
env.os.bits : 32
env.os.id : linux
env.os.platform : linux2
env.plugins.pi_support.model : Raspberry Pi 3 Model B Rev 1.2
env.plugins.pi_support.octopi_version : 0.16.0
env.plugins.pi_support.throttle_state : 0x0
env.python.pip : 19.0.1
env.python.version : 2.7.13
env.python.virtualenv : true
octoprint.safe_mode : false
octoprint.version : 1.6.1
printer.firmware : Prusa-Firmware 3.11.0 based on Marlin
systeminfo.generator : systemapi

2

Hello @Carls_Zarigata !

Obviously it is.

I'll recommend making a backup and make a new installation with OctoPi 0.18.1.

3

when i go into SSH and type python it goes to 3.5.....

4

Python 2 and Python 3 can be installed side-by-side. You happen to start Python3 when logged in via SSH, but the system is still running OctoPrint with Python 2.

NB: Even if you were to uninstall Python 2 from your Pi (keeping only Python 3) without doing anything else, OctoPrint would still be running using Python 2, because OctoPrint is typically run from inside a "virtual environment", which is basically a local copy of Python (which in your case is still set up to use Python 2). In order to make OctoPrint run with Python 3 it does not suffice to install Python 3; you have to rebuild the virtual environment using Python 3.

5
6

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.