What is the problem?
I have an old Nokia c100, and I came across Octo4A. I set everything up, and everything went smoothly until I tried actually connecting to my Ender 3 v1 with a motherboard v2.4.7. It wouldn't connect, even when changing baud rate and port to auto. Pretty sure it's my phone, but I want to know if there is any hope of using it.
What did you already try to solve it?
Increasing timeout, changing my OTG USB-C hub, putting tape on the 5v pin.
Have you tried running in safe mode?
yes
Did running in safe mode solve the problem?
no
Systeminfo Bundle
octoprint-systeminfo-20260119234211.zip (28.8 KB)
Additional information about your setup
Octo Print v1.11.5, Ender 3 v1 with motherboard v4.2.7, Nokia c100 running Octo4A