Octolapse: Getting the bed and extruder to move into the same position between layers


#1

Currently my timelapse snaps seem to be just wherever the printer happens to be between layer a change. I can't figure out how to configure my OctoPi so my bed (Y-axis) and extruder are in the same position each time when the pic is taken so I have one continuous smooth motion of printing. Is it possible to get my extruder to move 100-150mm directly above the print so it's doesn't take up too much of the camera view?

Are their any guides or tutorials that cover this?

Thanks


#2


place a position in the before and after
maybe with a minimal distance
and a super slow movement between