Octopi operational, but then times out?

Hello, I recently upgraded the firmware on a Prusa MK3S to 3.10.0. Octopi was working with my older version FW, but now it connects for a few seconds then it says Error: to many consecutive time outs? Does anyone have any suggestions or advice as to why this is happening and what approach I can take to maintain the connection without it timing out on me? Should I reconfigure/reflash octopi or do a factory reset on the printer? I am currently using octoprint version 1.5.3. Maybe I should upgrade it? I did disconnect the power panic button on my printer. Should I reconnect it? Any guidance on this issue would be much appreciated. If anyone could shed some light on this topic, I would be so grateful. Thanks again in advance.

One thread is enough

1 Like