Octoprint connect for cura not working with octolapse

What is the problem?

Octoprint connect won't connect to octoprint after octolapse was installed. I would rather not uninstall octolapse unless I have to so I was hoping there would be a different solution.

What did you already try to solve it?

Safe mode fixed the issue.

Have you tried running in safe mode?

Yes

Did running in safe mode solve the problem?

Yes

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
octoprint(2).log (37.5 KB)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Pi 4 2gb, skr mini e3 on an ender 3, cura 4.8.0 octoprint connect vision 3.5.18

I have had a issue connecting and not sure if my solution will work for you. I disabled the connectivity check and the ssh above it in the settings of octoprint. This made my connection a lot more stable and i was able to connect properly.

Hello @Dvlopez2010 !

You are digging out some really old threads. This one 3 years, the other 4 years.

To many things have changes since then...