Octoprint & Snpmaker A350 settings

Get Help
1

What is the problem?

Unsure on my printer settings for x, y, z . X mm/minute per axis.

What did you already try to solve it?

No

Have you tried running in safe mode?

No

Did running in safe mode solve the problem?

N/A

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

Octoprint is running with no issue, just want to be sure configuration for my printer is right. I will transition to Cura 5 when it is released from Luban.

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

Camera install in the next day or two, waiting for delivery . Running on an PI 4 w/8gb ram & 128 gb micro sd card. Unit has connected to printer.

2

You can run with 6000 mm/min for X and Y and 200 mm/min for Z.
These values are for the move commands in the Control Tab and do not effect the speeds that are in the gcode files.

3

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.