Octoprint Starts into safe mode

Get Help
1

What is the problem?

Octoprint starts into safe mode, but when restarted into normal mode, works fine,

What did you already try to solve it?

Checked octoprint.log, found python error

Have you tried running in safe mode?

N/A

Did running in safe mode solve the problem?

N/A

Complete Logs

octoprint.log (41.0 KB) serial.log (148 Bytes)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

  • Linux octopi 5.4.72-v7+ #1356 SMP Thu Oct 22 13:56:54 BST 2020 armv7l GNU/Linux
  • OctoPrint 1.5.2
  • Python 3.7.3
  • OctoPi 0.17.0

Thanks!

2

What makes you think that OctoPrint is booting into safe-mode? It appears from the log that it is botting normally.

3

Octoprint brings up a "Problem during last start up, Octoprint is in safe mode" message in the top right.
You can probably see me restarting Octoprint normally manually in the log also.

4

Closing as I ended up reinstalling after buying new Pi.
Sorry if you're getting this issue, looking for an answer!