Jamr
August 31, 2023, 1:11am
1
OctoPrint Stopped Parsing my Files
Restart OP and the printer.
Not yet.
WRITE HERE
octoprint-systeminfo-20230830180853.zip (60.8 KB)
WRITE HERE
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
Do you mean it stopped loading the files and show in gcode viewer? There's a bug in Firefox version 116+ recently identified that is causing this issue.
opened 01:57AM - 29 Aug 23 UTC
bug
not octoprint
### The problem
Large gcode files (> ~15 MB) loaded into OctoPrint will "parse"… to a given number (depending on the gcode; it seems to be consistent per file, but varies between files) and then stop. I can't find any errors in the console either. Smaller gcode files, however, work properly.
It seems to work in Chrome, but I do not use Chrome. I confirmed by turning off content blockers and using an effectively vanilla installation of Firefox (it had uBlock Origin installed, but I disabled that before testing) that it's not just a configuration issue with my local Firefox installation.
### Did the issue persist even in safe mode?
Yes, it did persist
### If you could not test in safe mode, please state why ("currently printing" is NOT an excuse!)
_No response_
### Version of OctoPrint
1.9.2
### Operating system running OctoPrint
Linux (Ubuntu 24.04)
### Printer model & used firmware incl. version
N/A
### Browser and version of browser, operating system running browser
Firefox 116.0 (persists across multiple OSes)
### Checklist of files to include below
- [X] Systeminfo Bundle (always include!)
- [X] Contents of the JavaScript browser console (always include in cases of issues with the user interface)
- [X] Screenshots and/or videos showing the problem (always include in case of issues with the user interface)
- [X] GCODE file with which to reproduce (always include in case of issues with GCODE analysis or printing behaviour)
### Additional information & file uploads
[octoprint-systeminfo-20230828002951.zip](https://github.com/OctoPrint/OctoPrint/files/12449163/octoprint-systeminfo-20230828002951.zip)
[console-export-2023-8-28_18-9-56.txt](https://github.com/OctoPrint/OctoPrint/files/12459233/console-export-2023-8-28_18-9-56.txt)
https://github.com/OctoPrint/OctoPrint/assets/605502/7c531928-ee16-459e-b43e-430cc3a160c1
[gcode that triggers issue (gunzip before using)](https://github.com/OctoPrint/OctoPrint/files/12459264/Gear.fidget.all.holes_0.1mm_Generic-PLA_SV04.gcode.gz)
Jamr
August 31, 2023, 4:20pm
3
That was it. I am currently running FF11603