OpenMiko wyzecam not loading in Octoprint

Camera model
Wyzecam v2 with OpenMiko firmware

What is the problem?
The flashed wyzecam works fine in my browser using the url:
However, using that in Octoprint, within the same browser session on my laptop, get webcam stream not loaded

What did you already try to solve it?
Not sure what to do as clicking on the link on the message does open the cam in a new tab, so the url itself is fine.

Logs (/var/log/webcamd.log, syslog, dmesg, ... no logs, no support)

Additional information about your setup (OctoPrint version, OctoPi version, ...)
Version 1.7.3

Hello @stain3565 !

Wyze cam seems to be a bit tricky:

If you access OctoPrint from its IP address, does that make a difference?

Also checking the browser console for that page will help you to find the error.

Not sure why but it did work after a couple of reboots