What is the problem? When I pause the print in prusa slicer to add a nut then print through octoprint, it will pause then resume, but no filament comes out. I haven't had problems with color change with this setup, so this is specific to the pause print. At this point I shut down octoprint and have in printing from my sd card. I have the Prusa MK#s+ and using prusa slicer 2.8
WRITE HERE
What did you already try to solve it?
WRITE HERE I searched this forum, but only old posts
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE