What is the problem?
WRITE HERE
Preheating from web GUI stops after 2 seconds.
Print starts without heating
What did you already try to solve it?
WRITE HERE
Tried failsafe mode
Have you tried running in safe mode?
WRITE HERE
Yes
Did running in safe mode solve the problem?
WRITE HERE
No
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Send: M104 S255
Recv: ok
Recv: T:23.79 /0.00 B:21.25 /0.00 @:0 B@:0
Recv: T:23.79 /0.00 B:21.21 /0.00 @:0 B@:0
Recv: T:23.75 /0.00 B:21.25 /0.00 @:0 B@:0
Recv: T:23.75 /0.00 B:21.25 /0.00 @:0 B@:0
Recv: T:23.79 /0.00 B:21.25 /0.00 @:0 B@:0
Recv: T:23.75 /0.00 B:21.25 /0.00 @:0 B@:0
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
Printer ender 3 pro All stock
Octoprint 1.5.2
Have been running as long I can remember flawless but now suddenly it behave like this.
Prints perfect from sd card