What is the problem?
Prints shift on specific layer via Octoprint but the same model prints perfect via SD card.
What did you already try to solve it?
Checked all belts, hardware and slicer settings. Printed same model from SD card. Came out perfect.
Have you tried running in safe mode and if so did it solve the issue?
No
Complete Logs
serial (1).log (609 Bytes)
WRITE HERE
Additional information about your setup
OctoPrint version 1.4, OctoPi version 4, printer - Cr10s Pro V2, stock firmware, Microsoft Edge, Cura slicer as much data as possible
All of the taller prints I had failed at the same level about 60-70% through the print. Some stringing and detail issues were fixed with print speed on SD card. I am hesitant to use this software for more than a glorified webcam. Can someone please check out my serial log and let me know how to fix it?