What is the problem?
Hey,
the problem is that if I start a print over octoprint it randomly stops/starts to print the same line all over.
At first I thought it is a problem with the TMC2208 Motor Driver, but then the problem appears all the time and not just with octoprint.
What did you already try to solve it?
Reduce Baud to 11500
Update
Additional information about your setup
Marlin 1.1.8
OrangePi Zero
Armbian 5.6
VertexK8400 with MKS GenL Motherboard
Cura 3.6.0
octoprint.log (50.8 KB)
serial.log was not activated.
Hope you can help me find the problem