Slicer (Sli3r, 1.3.1, X)
What is the problem? Parts are not the right size from my new Ender3 they are about 0.25mm too Large
**What did you already try to solve it?**Calibrated E-steps to X79.42, Y79.74, Z401.43 Cant seem to get them better then +0.08mm Can I get a more Accurate Result?
Logs (octoprint.log, serial.log or output on terminal tab, ... no logs, no support)
Example GCODE file
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware...)