Printer does not show up on OSX

[Gamecat34]

What is the problem?
I got octoprint running on my MacBook Pro, only Problem I got is octoprint does not recognize the printer. Only if I restart the mac, it works until I turn of the printer, after that the printer shows up in the usb section of the mac info, but Orctoptint does not see the serial. Installalled the newest drivers too. It a CR 10S Pro and shows up as FT232R USB UART.
What did you already try to solve it?
I installed the newes drivers.
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, octoprint.log, serial.log or output on terminal tab, ...)

[OutsourcedGuru]

Setup on mac does not finish

macOS should have issued the serial connection a device. Usually on my Mac within the OctoPrint -> Connection side panel widget the pull-down will indicate something new when I plug in a MEGA board via serial. You might have to run sudo dmesg to figure out the device. Or you might have to run ls -l /dev both before/after plugging it in, noting the difference. Since macOS will issued odd-looking device names compared to Linux, you might need to go into Settings -> Serial and add something to whe…