What is the problem?
Printer homes correctly to the lower left but when the print starts it goes to the complete right side of the bed and starts drawing lines up and down the side. Normally it is supposed to stay on the left to print a line up and down, then print the object.
What did you already try to solve it?
I dont really know what to try. I tried looking at the gcode itself but that looks normal. I really dont know and am frustrated.
Have you tried running in safe mode and if so did it solve the issue?
I have no idea what safe mode is and how it changes it.
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
Idk what to put here
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Homing works at the left side of the bed, then goes to the right and makes the lines and prints as if it was printing the thing. But is just printing it in a straight line on the side. On an Ender 3 V2 using Cura as my slicer.