What is the problem?
I've been messing with YoutubeLive settings this afternoon, and for some reason the printer now starts to pre-heat on Octopi/Octoprint start, where it didn't before.
I have no clue why this is happening, but I'd like to not have it pre-heat without my input.
What did you already try to solve it?
Not much. Pretty new to this
Have you tried running in safe mode?
Yes. The problem doesn't occur in safe mode
Did running in safe mode solve the problem?
Yes, until I run it in non-safe mode again....
Systeminfo Bundle
Hope this is enough, couldn't upload all files. due to size restrictions
plugin_pluginmanager_console.log (44.2 KB)
plugin_softwareupdate_console.log (30.9 KB)
plugin_softwareupdate_update.log (363 Bytes)
serial.log (148 Bytes)
webcamd.log (352.1 KB)
Additional information about your setup
OctoPrint version: 1.8.7, OctoPi version: 1.0.0, printer: Ender 3 S1, Stock, Safari, MacOS