Prusa i3 MK3S+ will not connect

[Hans_Vogels]

What is the problem?

Prusa i3 MK3S+ will not connect

What did you already try to solve it?

Everything I could find here in the forum.

Have you tried running in safe mode?

Yes

Did running in safe mode solve the problem?

No[octoprint-systeminfo-20211202133937.zip|attachment]

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

(upload://vrsZVyGDoujxV9qqeyxKoSU9Ic4.zip) (98.3 KB)
octoprint-systeminfo-20211202133937.zip (98.3 KB)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

The last version of Octopi. Printer is Prusa i3 MK3s+. Browser Google Chrome. Windows 11 OS.

[PrintedWeezl]

Make sure the rpi port is disabled if you want to connect it via usb.

OctoPrint won't connect to my Prusa MK3

If you are trying to connect to your MK3 or MK3s via a USB connection and it fails, make sure you have "RPi Port" set to "off" in the settings on your Prusa. ["RPi port" setting in the printer's settings] Other than the naming in the printer's settings might indicate "on" will simply make the USB port not work in favor of the GPIO pins on the Einsy. The mistake is hard to diagnose on first glance since there will be no error message generated by the printer, it will appear as a port to connec…

[Hans_Vogels]

Thank you for your advice, RPI was on. Now I can connect to my printer.