Prusa MK3S Firmware 2.2.0 superPINDA

When starting to print new file, it goes through the bed leveling process. then quits with error message "excessive bed leveling correction 2700 microns."

WRITE HERE

What did you already try to solve it?

Did Z calibration. restarted printer and Octoprint. Contacted Prusa Chat. It works fine from SD card, but not through Octoprint (1.3.12)

Have you tried running in safe mode?

YES

Did running in safe mode solve the problem?

NO

Complete Logs

EXCESSIVE BED LEVELING CORRECTION 2700 MICRONS
Also M112 Emergency Stop

WRITE HERE

Additional information about your setup

OctoPrint version (1.3.12), printer:Prusa MK3S 2.2.0 Google Chrome, oWin 10 64 bit
Updated to Octoprint 1.5.2: It worked for one (1) print, then went back to the same issue.

WRITE HERE

1 Like