Reset printed pieces (so that they appear in black after they have been printed once)

Hi! I would like to know if it is possible to reset the pieces already printed in Octoprint so that they appear again on the website in black instead of green. I would be interested in being able to do this because if I have to print several pieces from the same folder I can distinguish the ones already printed from the ones that are still to be printed.

Thank you very much,
Regards!!

What did you already try to solve it?

WRITE HERE

Have you tried running in safe mode?

WRITE HERE

Did running in safe mode solve the problem?

WRITE HERE

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE

Hmmm

Interesting feature idea. Just like mark watched/unwatched in Netflix

@foosel

I don't know... I used to call that a job control ticket. Just had to check off the step/parts worked on. Really simple to check what you had to do.

This thread might have value.