Resetting OctoPrint

So after updating OctoPrint to the newest release, It's been messing up. I haven't installed any new plugins. Just updated everything after a long set of prints. Now after it starts its nozzle purge (first pass), it goes to the center of the bed, then comes back and finishes the purge. after that, it starts the print. and every layer change it does the same thing, centers itself then proceeds to do the next layer of the print. I haven't changed any settings or installed new plugins or anything besides updating it. is there any way to reset octoprint back to default?

Try all this in Safe Mode to rule out your plugins.