Slicer / Print issue

Get Help Slicers
1

Slicer

Creality Slicer 4.8
Creality Slicer 4.8.2.279

What is the problem?

Once loaded into OctoPrint, all prints are not using center of bed as origin. Both slicer and GCode viewer are set to center & even though actual print is 200x200 Octoprint states build is out of area.. Bed is actually 235x235, and is set in Octoprint as well as Slicers

What did you already try to solve it?

changed setting from lower edge in Octoprint. reloaded both Pi and OctoPrint several times, tried several different .stl files

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

octoprint-systeminfo-20240814123100.zip (52.9 KB)

Example GCODE file

Please upload here, the forum supports file uploads of GCODE files

CE3E3_20x20.gcode (67.0 KB)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

Build 2024.06.18.10.101629 with Camera streaming, OctoPi 1.0.0 Raspberry Pi Model 3B+ Rev 1.3, MS Edge, Win10, 64Bit, Creality Ender 3D v1 Board 4.2.7 & CR Touch

2

Hi All.. Before some one picks this up... I may well have spoken in frustration... Please bear with me on this, i have found something incorrect in my slicer settings.. and going through all steps to ensure i can narrow down exactly where the issue lies..

3

ok.. Could someone please either delete this thread, or archive it as completed.. I have found the answer to the issue above.. It was my interpretation of the settings.. Using Centre Point as Start does not mean that logically, or literally.

4

Have you seen this small check-box? Try it.

grafik

5

Hi Ewald.. I had not..
Thanks for pointing out this to me..

1 Like