What is the problem?
I have been using Z offset command in Cura 5.1 to add 2nd color to top of print. Is there a procedure for removing first set of gcode and putting 2nd set of gcode in action.
What did you already try to solve it?
Presently I have to restart Octoprint to put 2nd gcode in place
Have you tried running in safe mode?
No
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
5.7 /7.00mm
Printer AnyCubic Vyper
Firmware 2.3.9
Browser Safari 15.6.1
MacOS 12.5.1
- OctoPrint 1.8.2
- Python 3.7.3
- OctoPi 0.18.0