What is the problem?
PSU Control Tapo not working as expected.
I have an ender 3 and there is a tapo PS115 on the power strip. I configured PSU control (Sensing=internal, Switching ->Plugin and I configured with the correct IP Address user e pw the Tapo Plugin) to switch off the printer after X minutes of standby. Unfortunately nothign happens...
What did you already try to solve it?
Have you tried running in safe mode?
no
Did running in safe mode solve the problem?
Haven't tried
Systeminfo Bundle
octoprint-systeminfo-20230119223351.zip (1.0 MB)
WRITE HERE
Additional information about your setup
Latest octopi running on a VM on a Qnap Server (everything works fine). The virtual server is on the switch and its address is 192.168.1.145 and it can reach (ping'ed) 192.168.1.62 which is the address of the TAPO.