Target temps not set?

What is the problem?
When saving a print (sliced in Cura) the bed and hottend target temps are not set.
All was working fine, printed one thing today with no problems but now it wont set the temp for any gcode i load.
Worst thing is it just wants to start printing even if temps are at ambient.
Using octopi.

What did you already try to solve it?
Checked out the gcodes and i think the right commands are given but it looks like octoprint doesnt see it and just wants fo start print with hotend at 21 degrees.
When i save file to sd card and print directly from the sd all temps are set correctly.

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, octoprint.log, serial.log or output on terminal tab, ...)
Printer is ender 3 with marlin software using octopi

Solved.. Seems like octolapse changed something, restored to default settings and all is good now.