What is the problem?
I have my build plate temp set to 70 in Cura. When I start the print, it wants to preheat the bed to 80. I have to manually change it, when i get to, before it starts laying plastic
What did you already try to solve it?
Confirm settings on extruder in Cura and Material profiles. Preheat settings in Octopi set correctly
Have you tried running in safe mode?
No
Did running in safe mode solve the problem?
N/A
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20230111201420.zip (169.1 KB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Octoprint - Version 1.8.6, Octopi - 0.18.0, Cura 5.2.1