Tevo Tornado Gold

Get Help
1

What is the problem?

I keep getting a disconnect from printer after a few seconds. And non of the prints that finish are close to those I dont use octoprint on. And I cant remote in to the pi unless I'm in my own network?

What did you already try to solve it?

Rebooted everything, different router, new power cord, new install of octoprint, updatefd

Have you tried running in safe mode and if so did it solve the issue?

No?

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE

2

Hello @Daniel_Golden!

Hint: Words written in blue (like safe mode) are links. :wink:

3

This is a GOOD thing. Exposing your RPi (and therefore you printer) to the internet at large could result in the building where you have your printer burning down. If you need/want remote access, there are numerous solutions available that are substantially safer.