What is the problem?
I get the following message
X/Y
Z
0.1 1 10 100
Feed rate modifier:
% Set
Tool (E)
mm
ExtrudeRetract
Flow rate modifier:
% Set
General
Motors offFan onFan off
-
OctoPrint 1.5.2
-
Python 2.7.16
-
OctoPi 0.17.0
-
[ About](javascript:void(0))
-
[ System](javascript:void(0))
Invalid tool reported
Your printer reported tool T0 as invalid, reverting back to T0
Suppressed command
The command T0 was not sent to the printer:
Not queuing T0, that tool doesn't exist according to the printer profile or was reported as invalid by the firmware. Make sure your printer profile is set up correctly.
What did you already try to solve it?
Checked my printer profile, checked the forums
Have you tried running in safe mode and if so did it solve the issue?
no, it didn't
Complete Logs
octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware
the latest version of Octoprint