What is the problem?
I have followed the update instructions for both pi imager and manual
but both when I open octoprint it still shows 0.17
I am putting the SD card into pi and turning on is there something else I need to do to make it update - sorry if this is just a Noob question
What did you already try to solve it?
Repeated instructions several times
Have you tried running in safe mode?
yes
Did running in safe mode solve the problem?
no
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE