What is the problem? The server hangs during the print, the print continues, but octoprint does not update the progress, is not aware when the print ends, does not run the post print gcode and requires a reboot to re-establish UI. The print then shows as a failure and the timelaps video is lost.
What did you already try to solve it? Don't know how to proceed.
Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, octoprint.log, serial.log or output on terminal tab, ...)
Version 0.15.1, running on Raspberry Pi 3 Model B Plus Rev 1.3
Creality CR-10 mini
TH3D_UFW_U1.R2.7 with EZABL
octoprint (2).log (193.4 KB)
I've been running octoprint for over a year and recently updated everything when I replaced my Pi.
thanks