Where is the best place to mount the Raspnerry Pi 4 (Octopi) in the Ender 3 v2
Where can i mount the Raspberry Pi 4 ?
WRITE HERE
Have you tried running in safe mode?
N/A
Did running in safe mode solve the problem?
N/A
Complete Logs
octoprint.log
, serial.log
or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE