What is the problem?
In my Octoprint Version 1.10.2 the dashboard always starts to layer zero while the GCode utilities (gcode viewer etc) start at layer 1. Am I missing something or are my settings wrong somewhere. System info is attached.
octoprint-systeminfo-20240908085609.zip (373.2 KB)
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE