Zits and blobs that go away after restarting Octoprint

What is the problem?

I get zips and blobs occasionally due to the head stopping intermittently during a print.

What did you already try to solve it?

Restarting my Pi 3B+ will fix it, but it comes back after a while.

Have you tried running in safe mode?


Did running in safe mode solve the problem?


Complete Logs

It just happened and I restarted before grabbing logs. Can attach next time it happens

Additional information about your setup

Pi 3B+
OctoPrint version : 1.5.3
OctoPi version : 0.17.0

I've also been thinking about adding a cronjob to reboot, but I would want a check to ensure a print isn't active. Has anyone done this before?

Then try running in safe mode.

Please provide details on your printer as well. Make, model, firmware type, firmware version.