What is the problem?
When i put a temp in for the bed on a Flashforge Creator Pro octoprint just sets it to off again and when i try to heat the left extruder it starts heating the right one instead.
What did you already try to solve it?
taking out the sd card
Have you tried running in safe mode?
no
Did running in safe mode solve the problem?
n/a
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Linux laptop plugged into the Flashforge Creator Pro.