Ender 3 S1 - Filament runout sensor - plugin

Plugins
1

Greetings,

Has anyone successfully managed to workout with one of the filament runout plugins to sense if the new Creality Ender 3 S1 - original runout sensor sends a runout signal?
As far as I saw in the logs there was no code sent to OctoPrint by the sensor.

Thanks forward

2

Hello @Tamas_Molnar !

These plugins are meant to connect the sensor to the Pi. They can not detect a runout from a sensor that is connected to the printer.

For the latter case, the printer firmware has to inform OctoPrint about a runout by an action command.

You may have a look on this thread:

1 Like