What is the problem?
when Raspberry Pi is connected to the Printer, Printer start Leveling and thereafter stop and count the % Progress upwards on the printer.
I receive follow Error in the octoprint interface "Failed to enable Bed Leveling".
This only happen if the Raspberry Pi is connected to the Printer, if it is Disconnected normal operation of the Printer
What did you already try to solve it?
restart printer and octopi
search in forum
covered PlusPin of the USB
Have you tried running in safe mode?
Yes
Did running in safe mode solve the problem?
No
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
octoprint-systeminfo-20211024153140.zip (18.7 KB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware,
, operating system, ... as much data as possible
Octoprint Version 1.7.0
Octopi Version 0.18.0
Ender 5+ including Silentboard