Recently reinstalled octoprint I'm getting an error M141 S28 heater box or something not installed code was not sent to printer
I've checked my E3 V2 profile in Octoprint & Cura but the code is not there any ideas what could be causing it I'm not familiar with writing code? Thanks
Hello @Solcutter !
This is an issue for the sub forum Get Help. I'll move it for you.
Please provide the following information.
What is the problem?
WRITE HERE
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, .... as much data as possible
WRITE HERE
Maybe a plugin is the culprit.