Hello everyone, I'm trying to put octoprint on my mingda magician x but the site doesn't detect the usb/usb-c port (I tried with hollow vases) do you know how I can do it? thanks

What is the problem?

the printer does not detect my usb/usb-c cable

What did you already try to solve it?

I tried with various cables but nothing

Have you tried running in safe mode?

yes

Did running in safe mode solve the problem?

no

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

octoprint-systeminfo-20240818180437.zip (29.5 KB)

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

OctoPrint version 1.10.2 , OctoPi version latest version , printer mingda magician x, firmware 1.6.6.6, browser brave, operating system windows 11, ... as much data as possible

Hello @GodNev3r !

Ever thought about putting your request into the text and not to the topic?

oh sorry, in which section should I go to ask this?

In

Here you put your request.

A little sleuthing around leads me to believe that the firmware in the printer is some flavor of Marlin. An optional side project, you should contact Mingda and ask them for the firmware sources as they are required by the Marlin license to make it available.

There are three hardware ports, a USB-A, an SD card slot, and a USB-C. The USB-A appears to be used for flash drives with gcode files similar to the SD card. That leaves the USB-C port as a possible connection point. Please follow the steps documented in the following forum topic including the step using a cell phone to verify that you have a USB-A to USB-C data cable.

https://community.octoprint.org/t/no-connection-at-all-with-elegoo-neptune-2/33519