Octopi Octoprint Pi Cam not working

What is the problem?
Under the Controls tab in Octoprint the Camera only shows "Webcam Stream Loading"
Raspberry Pi is a 3 B +
Camera is the Pi Cam V2 with IR sensor

What did you already try to solve it?
Rebooting, Trying different cable between pi and pi-cam, checking that the stream URL is "/webcam/?action=stream"
Read through this forum.

Additional information about your setup (OctoPrint version, OctoPi version, printer, firmware, octoprint.log, serial.log or output on terminal tab, ...)

OctoPrint 1.3.8 running on OctoPi 0.15.1
Creality CR-10S,

when I type in my octoprint ip with the camera port (192.168.0.130:8080) it still just sits and spins.

Any help is appreciated.

What did you do to resolve this? I am having the same issue.

i am very new and did encounter some camera issue during installation and i managed to solve it by

sudo raspi-config

enable camera in the options

sudo reboot

i am using pi cam v2 ...hopefully that can help you :slight_smile: