What is the problem?
Printer stops extruding during print from octoprint.
What did you already try to solve it?
Replacing cable with a newer one, restarting octoprint, reslicing the gcode
Have you tried running in safe mode?
Yes
Did running in safe mode solve the problem?
It still happened.
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support! )
Where do you get this?
*Found it
octoprint-systeminfo-20230922131936.zip (1.4 MB)
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Ender 3 with creality 4.2.7 silent board, custom firmware, running octo4a with many plugins, octoprint version 1.9.2
Hello @Masa_de_Man !
Masa_de_Man:
Where do you get this?
Hint: Blue words like systeminfo bundle / safe mode are links for more info.
It prints fine when using the sd card, but it stops extruding after some time with octoprint.
I had a look on your octoprint log.
It looks qutie messy. A lot of error message from the system:
2023-09-20 06:17:02,699 - octoprint.util.comm - ERROR - Could not scan /dev for serial ports on the system
Traceback (most recent call last):
File "/usr/lib/python3.10/site-packages/octoprint/util/comm.py", line 211, in serialList
with os.scandir("/dev") as it:
PermissionError: [Errno 13] Permission denied: '/dev'
and a ton of other errors
On a tiny side note I saw you run Octo4a.
Did it run before properly?
Yes, this issue only happens every now and then and with certain prints. Usually, reprinting or reslicing helps.
I did try looking for another topic about this, but the topic was closed before a solution was found.
Printer stops extruding after some time - Get Help - OctoPrint Community Forum
system
Closed
December 24, 2023, 2:07pm
8
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.