Raspberry pi 400

[AlexSievewright]

What is the problem?

wont load octoprint

What did you already try to solve it?

re flashed the image file with etcher

Have you tried running in safe mode and if so did it solve the issue?

don't know how to do that

Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

no log

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

pi 400 octoprint 2019-9-26

[Charlie_Powell]

This board requires newer software

See the OctoPi 0.18 RC1 release blog post, which adds compatibility with the Raspberry Pi 400:

OctoPi Release Candidate 0.18.0rc1 needs testers!

Guy Sheffer just published a release candidate for the next release of the OctoPi image, version 0.18.0. Apart from adding support for the Pi 4 8GB and the Pi 4 and of course shipping with the current stable OctoPrint version 1.4.2 now running under Python 3, 0.18.0rc1 also contains the following changes: Changes in the image OctoPrint 1.4.2 OctoPi now uses Python3 /home/pi/scripts/safemode (thanks @OutsourcedGuru) Fix #619 Shutdown requires network (Than…

[AlexSievewright]

thanks mate ill give them a try just downloading now will reflash sd card with this

[AlexSievewright]

so i get this far what do i do for login and password

[Ewald_Ikemann]

The standard login at that point is pi and the password is raspberry.
But you reach the backend there, not the usual OctoPrint web interface.

[AlexSievewright]

cool I've done that now my pc can't find it lol put ocopi.local in 3 different web browser's and nothing come's up I've looked in network settings i can see my tv my sky box my xbox but cant see the pi and dont know what the ip address is to find it that way either
also thanks for all your help so far lol

[AlexSievewright]

I'd like to thank everyone for their help I now have octoprint working on my raspberry pi 400 will connect it to my ender 3 tomorrow and test its control...

[AlexSievewright]

Connected to ender perfectly machine running a lithoplane as a test. Only thing cant work out is how to change the pi's login and password from the default pi and raspberry

[Charlie_Powell]

When you have logged in, (I'm pretty sure) the command is passwd and it should prompt you to change this.

Or, you can run sudo raspi-config and change it using that.

[AlexSievewright]

Ok so I just type passwd and I can change it
Or type sudo raspi-config and change it
Cheers for all your help