Server stopps during Print
WRITE HERE
WRITE HERE
WRITE HERE
WRITE HERE
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
Yes Ewald that's exactly what Octoprint delivers! a message telling me to restart the server because it had stopped.
There is a half-finished print on the printer, bed & nozzle are heated and the printer is waiting for print commands.
After restarting and reprinting it sometimes works, but mostly the same error.
All this after Update to 1.10.3.
previously it ran without errors
And what about this?
octoprint errors out frozen. 4.2.7 board. raspberry pi 5. new cables new power supply. fresh octoprint install. safe mode when trying to download systeminfo bundle it says trying to connect to 127.0.0.1 ERR_CONNECTION_REFUSED. printer prints prefect from sd card.
Did you create a new account or are you a different user?
That was not the question of @PrintedWeezl !
If you are not @wernerH, then do not take away a thread from another user. Open your own one.
sorry didnt know
sorry how do i do this
