What is the problem?
For an unknown reason, Octoprint is trigerring a pause on my prints. The behavior really to be a M600 like command (putting the nozzle on Z+5 and X0) and perfoming a filament retraction for like 30mm (my CR-10 bowden tube). I checked the Gcode: No M600 command in it. I am actually to print the exact same file through USB.
What did you already try to solve it?
Check the Gcode
Activate Serial logs (to ensure the issue was not ink to other threads)
On-going: Printing the same Gcode from SD
Next: Printing through Octoprint without any plugins activated.
I also tried several pausing conditions:
- Pausing from octoprint: the print is paused and the nozzle secured. The printer displays "Paused" and the filament is not pulled out. When resuming the print from octoprint, everything is starting back
- Pausing triggered by the filament sensor: I have exaclty the same behavior.
What's happening in my case: the job is paused AND the filament is pulled out. I absolutely need to click my CR10, first to reheat the nozzle. Once done, I need to click again to pull the filament in (and purge the nozzle) and finally I can either resume the print or perform another purge. Resuming the print from octoprint has no effect.
Have you tried running in safe mode and if so did it solve the issue?
not yet tried
Additional information about your setup
Print: CR-10 v2
Running on: Marlin 126.96.36.199