Tell me how my G-CODE should look

What is the problem?

I posted a topic a few days ago and not one response.

Can someone please just tell me what my G-Code needs to be. I know there are a lot of factors that go into that, but I just want a response. I've been at this for a week now.

What did you already try to solve it?

Here is my G-Code via Matter Control
G28 X0 Y0 Z0 ; home all axes
G1 Z5 F5000 ; lift nozzle
M109 S[temperature] ; set the extruder temp and wait
G28 X0 Y0 Z0 ; Home Z again in case there was filament on nozzle
G29 ; probe the bed

Have you tried running in safe mode?


Did running in safe mode solve the problem?


Complete Logs

octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)

Would be happy with a simple reply from someone.

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

Pretty obvious to see I'm a NOOB, just want some help. Appreciate your knowledge. Thanks !!

2 posts were merged into an existing topic: Webcam not capturing during prints in Octolapse