What is the problem?
I posted a topic a few days ago and not one response.
Can someone please just tell me what my G-Code needs to be. I know there are a lot of factors that go into that, but I just want a response. I've been at this for a week now.
What did you already try to solve it?
Here is my G-Code via Matter Control
G28 X0 Y0 Z0 ; home all axes
G1 Z5 F5000 ; lift nozzle
M109 S[temperature] ; set the extruder temp and wait
G28 X0 Y0 Z0 ; Home Z again in case there was filament on nozzle
G29 ; probe the bed
Have you tried running in safe mode?
yeah
Did running in safe mode solve the problem?
No
Complete Logs
octoprint.log, serial.log or output on terminal tab at a minimum, browser error console if UI issue ... no logs, no support! Not log excerpts, complete logs.)
Would be happy with a simple reply from someone.
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
Pretty obvious to see I'm a NOOB, just want some help. Appreciate your knowledge. Thanks !!