Unable to connect after PC rebuild

Get Help Networking
1

What is the problem?

I recently had to rebuild my PC due to a win11 update issue. when I tried to establish my octopi connection, it failed

What did you already try to solve it?

I looked at the FAQ and determined that I needed help. I created the Bundle as required, and ran "dmesg" on the RPi 3. results are attached.

Have you tried running in safe mode?

no i don't know how

Did running in safe mode solve the problem?

NO

Systeminfo Bundle

octoprint-systeminfo-20260205165317.zip (7.0 KB)

Additional information about your setup

dmesg
dmesg765×219 9.21 KB

RPi 3 updated, Octopi latest download, all cables are from the unit that was working fine.

2

Ok, appears you are actually using the windows install of OctoPrint that I made, and not running OctoPrint on the pi. This will generally work, but you would connect your printer directly to your windows machine. And if that that's what you are doing then there are a couple of things you would also need, in most cases the CH340 driver for windows needs to be installed.

The way you connect to OctoPrint running on a pi is to access it's ip address or .local address via a browser. So if your pi's ip address is 192.168.1.2 you would go to http://192.168.1.2/.