Dear Octopi fans!
I am using Octopi since a couple of weeks on an Raspberry PI4 with 4Gb and i am really happy with.
There is only one thing i am a little bit frustated:
Warts form on the surface of the components.
See the pictures here on Amazon photos:
https://www.amazon.de/photos/share/jritMyJ1wt4QdKyZUWYhaXutFZXR1amlROa5Ho2qupM
In an other forum they told me to ask you here, because they think the warts come from Octopi or the Raspberry, due to the fact that i do not have them, when i am printing from the SD card plugged into my Ender 5 Plus.
Do you have any tipps for me to reduce / solve this issue printing with Octopi?
Many thanks in advance!
Cheers, Bertl
Your printer probably stutters sometimes but we need the serial log to identify the problem.
Enable serial logging and upload a systeminfo bundle.
Also please fill out the form. It makes it much easier to help you 
Then we need to know at which speeds your were printing when that happened (wall speeds (outer wall in particular)).
What is the problem?
WRITE HERE
What did you already try to solve it?
WRITE HERE
Have you tried running in safe mode?
WRITE HERE
Did running in safe mode solve the problem?
WRITE HERE
Systeminfo Bundle
You can download this in OctoPrint's System Information dialog ... no bundle, no support!)
WRITE HERE
Additional information about your setup
OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible
WRITE HERE
1 Like