Wifi, configuration after installed

[merlinorn]

I have always used octoprint with an ethernet network, when I installed it I did not configure the wifi data, now I had to move the printer and octoprint to a place in the house where there is no network cable. How do i configure the wifi? thank you!

WRITE HERE

What did you already try to solve it?

WRITE HERE

Have you tried running in safe mode?

WRITE HERE

Did running in safe mode solve the problem?

WRITE HERE

Systeminfo Bundle

You can download this in OctoPrint's System Information dialog ... no bundle, no support!)

WRITE HERE

Additional information about your setup

OctoPrint version, OctoPi version, printer, firmware, browser, operating system, ... as much data as possible

WRITE HERE

[Ewald_Ikemann]

You may have a look on this:

WiFi setup and troubleshooting

A number of people who have followed the instructions for setting up OctoPi on your Raspberry Pi experience problems getting connected to WiFi. This thread is intended to detail a couple of common problems people have experienced and things to try to resolve them. This page assumes that your WiFi network is up and working and that other devices are able to connect to it without a problem. We are also assuming that you have already successfully downloaded the OctoPi image and "burned" it on to y…

[merlinorn]

thanks..i tried do it but don't work

[merlinorn]

forget it... now it works...but...i try to connect witth http://octopi.local but he refused connection...it's work only after foud the octopi ip address in my router, and work only with ipt. what i'm doing wrong?