Can NOT connect to MKS SGEN L

Can NOT connect to MKS SGEN L

Tried to add USB ports - Unsuccesfully

OctoPi Terminal ;

Changing monitoring state from "Offline" to "Detecting serial port"
Serial port list: [u'/dev/ttyACM0', u'/dev/ttyS0']
Trying /dev/ttyACM0
Could not connect to or enter programming mode on /dev/ttyACM0, might not be a printer or just not allow programming mode
Trying /dev/ttyS0
Could not connect to or enter programming mode on /dev/ttyS0, might not be a printer or just not allow programming mode
Changing monitoring state from "Detecting serial port" to "Error: Failed to autodetect serial port, please set it manually."
Failed to autodetect serial port, please set it manually.
Changing monitoring state from "Offline" to "Detecting serial port"
Serial port list: [u'/dev/ttyACM0', u'/dev/ttyS0']
Trying /dev/ttyACM0
Changing monitoring state from "Offline" to "Detecting serial port"
Serial port list: [u'/dev/ttyACM0', u'/dev/ttyS0']
Trying /dev/ttyACM0
Could not connect to or enter programming mode on /dev/ttyACM0, might not be a printer or just not allow programming mode
Trying /dev/ttyS0
Could not connect to or enter programming mode on /dev/ttyS0, might not be a printer or just not allow programming mode
Changing monitoring state from "Detecting serial port" to "Error: Failed to autodetect serial port, please set it manually."
Failed to autodetect serial port, please set it manually.
Could not connect to or enter programming mode on /dev/ttyACM0, might not be a printer or just not allow programming mode
Trying /dev/ttyS0
Could not connect to or enter programming mode on /dev/ttyS0, might not be a printer or just not allow programming mode
Changing monitoring state from "Detecting serial port" to "Error: Failed to autodetect serial port, please set it manually."
Failed to autodetect serial port, please set it manually.

Let's see what dmesg says

Log into your pi via ssh then disconnect your printer, connect it again, enter dmesg | tail -n 20 and post the output here.

thanks;

BEFORE UNPLUG;

AFTER UNPLUG;

AFTER RECONNECT;

Serial port choices in OctoPi;

Alright at least it's detected correctly.

It could have something to do with this part
grafik

Is your power supply sufficient? Do you get those warnings also with no usb device connected?

If you got a decent power supply and don't get this warning without the printer connected try this

nope - WHY can I not set / save serial connection in Octopi ?? seems 'stuck' ??? Should I try to reinstall octopi from scratch ??

reinstalled a fresh copy of Octoprint (mine was 18mnths old ) - BINGO - thanks for your help